If you love canoeing, you need to know how to properly transport your canoe. Getting a roof rack is a good idea and you can have one fitted to any car.
The problem comes when you have to tie your canoe to the roof rack. This can be daunting when you first do it, but following certain steps will make it much easier.
- Lay The Straps Over The Bars
The first step of tying your canoe to the roof rack is to lay the straps over the bars of the roof rack.
When you do this, you should ensure the buckles do not hit your car and scratch it. The straps should be threaded under and around each bar before resting flat against the car.
The straps will have 2 distinct ends. One end has a metal clamp or buckles while the other does not.
You should rest the buckle side of the strap against a window or other non-metal parts of your vehicle.
- Place The Canoe On The Rood Rack
Once the straps are in place, you can put the canoe on the roof rack. The canoe should be placed hull-side down if you are tying it directly to the rack. If you are a beginner, then have a look at this to get the best.
This will reduce the chances of indentations which affect the canoes ability to track straight.
If you are using carrier pads and other attachments such as rollers, you can place the canoe right side up.
The design of your canoe will affect whether you should place it facing the front or rear of your car.
If you have a canoe which has been designed with better frontal aerodynamics, you should have it facing forwards. This will provide you with less resistance as you drive.
It is important to note that most recreational canoes will not have much difference in front and rear definition which means you can place it either way.
When you place your canoe on the roof rack, you need to ensure that it is centered on the crossbars. This will provide better weight distribution and make it easier for you to drive.
- Bring The Straps Over The Canoe
Once you have the canoe on the roof rack, you need to pull the straps over the canoe. When you do this, you have to be careful and avoid hitting the buckle side of the straps against the car.
This can cause damage to the bodywork and the windows.
If you have a large canoe, getting the straps over can be hard, but you need to do this correctly.
To bring the straps over, you need to take the buckle end and walk it around the end of the vehicle and over the canoe. This should hang down as you pull on the other end of the strap to get more length.
You should then toss the non-metal end of the strap over the canoe. This will get the strap over your canoe without damage to the vehicle or any injuries.
- Secure The Straps
With the straps in place, you can now secure them. The straps should be laying flat against the canoe and should not be crossed. You can then slide each of the straps so the buckle is against the hull of your canoe.
You should then bring the other end of the strap under the crossbar and up to meet the buckle. You should then thread the strap into the buckle and pull them to take up the slack.
Once the straps are threaded through the buckles, you will need to tighten them. The buckles on the straps are one-way clamps and allow movement in one way only.
You will want the straps tight to keep the canoe in place. If you are going to leave your canoe on the roof rack overnight, you should loosen them and tighten them before you leave.
Tying your canoe to your roof rack can be daunting the first time you try this, particularly if you have a large canoe.
To do this correctly, you should lace the straps first and then put the canoe on the roof rack.
After you have secured the straps, you will need to tie them up to stop them flapping as you drive and hitting your car.